Join the 155,000+ IMP followers

electronics-journal.com
Keysight technologies News

KEYSIGHT SHOWCASES SOLUTIONS ACCELERATING AI ADOPTION AT OFC 2024

Keysight will demonstrate its market-leading design, simulation, and test solutions that accelerate the adoption of AI through the validation of high-speed optical and electrical technologies.

KEYSIGHT SHOWCASES SOLUTIONS ACCELERATING AI ADOPTION AT OFC 2024

The use of AI is growing rapidly and the race to develop and deploy high-speed, high-bandwidth optical interconnects is a top priority for data center and cloud service providers.

Join Keysight experts from March 26-28, at Booth #3701 at San Diego Convention Center for the following demonstrations:

PCIe® 7.0 technology over optics: Keysight presents a low-power PCIe 7.0 optical interconnect technology supporting emerging large language model needs for higher efficiency signaling using Eoptolink 800G DR8 linear pluggable optics.

Linear drive optics: Linear drive optical transceivers exhibit lower latency, power consumption, and cost than traditional re-timed transceivers making then an ideal solution for AI applications. This demo showcases Keysight's validation solutions for the CEI-112G-Linear-PAM4 standard on linear pluggable optics, including new measurements such as EECQ (Electrical Eye Closure Quaternary) and new reference receiver equalization techniques.

224G TX and RX validation with new 64 GHz interference source:
Keysight demonstrates a 224G receiver test with interference tolerance as well as intersymbol interference (ISI) and bit error ratio (BER) measurements based on built-in counters of a SERDES chip. This includes Keysight's new M8053A 64 GHz Interference Source that enables interference tolerance test of receivers that operate up to 120 Gbaud PAM4. The 224G transmitter validation is performed on a 5 nm 224G Phy, illustrating jitter decomposition, SNDR, and Partial Response Maximum Likelihood Sequence Estimation (PR-MLSE) equalization.

800ZR transceiver test: New interoperability solutions in 800ZR, 400ZR, and OpenZR+ optics are needed to address the unprecedented demand for next-generation network solutions that will support future AI needs. For the first time, Keysight will demonstrate signal analysis on 800ZR high-speed coherent pluggable optics from multiple vendors at both the physical and the protocol levels. The demo includes Keysight's Optical Modulation Analyzer to measure physical layer transmitter characteristics to characterize and validate 400ZR / 800ZR pluggable modules. In addition, layer 1-3 testing will be performed using the AresONE 800GE-M Dual Interface Model Network Tester in a single platform for 800GE, 400GE, and 100GE with PAM4 and NRZ signaling, with up to 106.25 Gb/s host electrical lane.

Pathway to 448G optics: Keysight uses a Mitsubishi Electric Corporation externally modulated laser (EML) running far above current 106/113 GBaud rates to demonstrate the progression to 448G optics by generating signals and test waveforms to 180 GBaud and verifying 200G TDECQ (Transmitter and Dispersion Eye Closure Quaternary).

Photonic IC testing: Collaborating with FormFactor, Keysight presents a complete measurement automation and probing solution for photonic integrated circuits (PIC). The demo will show how to verify wafer / die PIC modulator and photodetector designs for optoelectronic S-parameters, S (lambda), and polarization-dependent responsivity / insertion loss using a measurement algorithm to seamlessly control wavelength, biasing, and polarization.

Learn more about OFC 2024

www.keysight.com


  Ask For More Information…

LinkedIn
Pinterest

Join the 155,000+ IMP followers